The recommendations on evaluating and improving algorithm reliability for shortening the development cycle of deep learning algorithms and improving the quality of software systems based on deep learning algorithms are…
Construction, application, and testing considerations for electric motor operators and accessories for use with high-voltage switches and interrupter switches rated above 1000V, as covered in IEEE Std. C37.30.1 and Std…
Uniform procedures for the measurement of the power frequency electric field and dc electric field when ac/dc power transmission lines are installed in parallel or on shared towers are established…
This document describes near-field test practices for the measurement of antenna properties. It is written for the person responsible or otherwise involved in operating the test system. It recommends procedures…
This guide discusses both on-line and off-line partial discharge (PD) measurements on complete windings of any type, as well as measurements on individual form-wound coils and bars. Measurements selected from…
This standard sets terms, test methods, test circuits, measurement procedures and preferred result values for silicon thyristor-based surge protective components used for overvoltage or overcurrent or both protection in low-voltage…
Guidance for technical requirements for the design, fabrication, testing, and installation of indoor gas-insulated substations (GIS) 1 kV up to 52 kV is provided in this standard. Parameters to be…
An electric penetration assembly is an assembly of insulated electric conductors, conductor seals, module seals (if any), and aperture seals that provides the passage of the electric conductors through a…
It is required that Class 1E motors, with their interfaces, meet or exceed the specified performance requirements throughout their service life. This is accomplished through a program that includes, but…
