Herein, we describe a simple laboratory experiment to address nanomaterial synthesis, plasmon resonance, and its application to detect Cu[superscript 2+] in ultralow concentrations. The proposed experiment is very visual and appealing for chemistry students, especially the undergraduate-level chemistry major. In this experiment, the aggregation of…

In a traditional teaching approach, a physics course begins with mechanics, and generally the braking effect due to magnetic interactions is not mentioned among the various types of friction presented (static, sliding, rolling) because students will discover magnetism only in later chapters. In our didactic experience this traditional choice is…

The article describes research work that can help students observe and experimentally research the effects caused by the emission component of the filament current in fluorescent lamps' cathodes. When analysing the work of electronic devices--multi-purpose lamps that use thermionic emission--research usually focuses on the current caused by the…

A method is described to measure the coefficient of restitution (COR) by dropping a ball on a piezoelectric disk. Multiple bounces can be observed at small drop heights, so the average COR over say ten bounces can be obtained from just one ball drop, without having to measure the bounce height or the bounce speed. The results show directly that…

A flash purification system using prepacked cartridges containing different silica weights and particle sizes was employed to demonstrate the influence of column characteristics on chromatographic resolution. This chromatographic experiment was a helpful introduction to chromatographic courses where the influence of particle sizes was addressed…

In this article, we describe an in-house polymerase chain reaction-sequence specific priming (PCR-SSP) assay designed for undergraduate medical students as part of the experimental pathogen biology and immunology (EPBI) course. It screens human leukocyte antigen (HLA)-DR2 allotype from genomic DNA samples using a rapid and single-tube PCR…

Smartphones and their internal sensors offer new options for an experimental access to teach physics at secondary schools and universities. Especially in the field of mechanics, a number of smartphone-based experiments are known illustrating, e.g., linear and pendulum motions as well as rotational motions using the internal MEMS accelerometer and…

A two to three period analytical chemistry experiment has been developed which allows second year students to explore chemical color tests used to detect adulterated pharmaceuticals. Students prepare several paper analytical devices (PADs) to generate positive and negative controls antibiotics, along with cutting agents such as starch and chalk.…

This work presents the design of an inexpensive electronic system to measure water temperature and generate an experimental data set used to verify the fitting between experimental and theoretical curves of a water-cooling process. The cooling constant is computed with three different theoretical methods to check their efficiency and this approach…

Light spectrum dispersion is an exciting subject in science because of its beautiful atmospheric colour phenomenon which attracts students. However, to see the phenomenon is not easy since it needs a spectrometer, which is commonly expensive. Therefore, the present study aims to describe a low-cost spectrometer for investigating lighting spectrum…

Air pollution is one of our day's significant reasons for human health problems and affects every community throughout the world. Monitoring air pollution is a key aspect of raising awareness and pollution mitigation approaches followed by different nations. This paper targets to develop a low-cost Internet of things-based embedded system to…

The flight of a quadcopter drone, readily available as a toy, is analyzed using simple physics concepts. A smartphone with built-in accelerometer and gyroscope was attached to the drone to register the accelerations and angular velocities along the three spatial axis while the drone is taking off, landing or rotating. The vertical speed, the…

Marble, formed by the metamorphism of limestone, is commonly used in the construction industry and sculpting. The mineral in marble is either calcite [CaCO[subscript 3]] or dolomite [CaMg(CO[subscript 3])[subscript 2]] or sometimes both. The pure white Carrara marble from Italy was made a household name by Michelangelo, the famous sculptor of the…

As part of their third-year general chemistry program, students at the University of the Côte d'Azur are taught the basics of radioactivity. The view that third-year university students have of the periodic Table of the Elements is often reduced because it ignores the vast majority of isotopes. As part of this program, a practicum devoted to the…

The current pandemic era demands distance learning, including physics experiments on the topic of optics. One of the optical phenomena that needs to be explained in optic courses is fluorescence. This study offers a simple home experiment regarding the application of fluorescence, namely to identify the purity of olive oil using simple…