A multi-instrument approach has been applied to the efficient identification of polymers in an upper-division undergraduate instrumental analysis laboratory course. Attenuated total reflectance Fourier transform infrared spectroscopy (ATR-FTIR) is used in conjunction with differential scanning calorimetry (DSC) to identify 18 polymer samples and…

Gas chromatography-mass spectrometry (GC-MS) is a powerful analytical tool for detection, identification, and quantification of many volatile organic compounds. However, many colleges and universities have not fully incorporated this technique into undergraduate teaching laboratories despite its wide application and ease of use in organic…

This paper discusses the design and implementation of laboratories and course projects using LabVIEW in an instrumentation course. The pedagogical challenge is to enhance students' learning of digital communication using LabVIEW. LabVIEW was extensively used in the laboratory sessions, which better prepared students for the course projects. Two…

Calibration is a technique that is commonly used in science and engineering research that requires calibrating measurement tools for obtaining more accurate measurements. It is an important technique in various industries. In many situations, calibration is an application of linear regression, and is a good topic to be included when explaining and…

Presents a low cost system with easily replaced electrodes for use in general chemistry. Notes the accuracy and wide applicability permit easy use in physical or quantitative chemistry experiments. Provides schematic, theory, and helpful suggestions. (MVL)

Announces the incorporation of a laboratory information management system (LIMS) into the academic environment. Describes the applications of a computer-automated laboratory system at one university. Stresses the benefits to students of the use of such a system in terms of entry into the industrial environment and to professors in grading. (CW)

Describes four physics experiments including "Investigation of Box Resonances Using a Micro"; "A Direct Reading Wattmeter, DC or AC"; "Exercises in the Application of Ohm's Law"; and "Hysteresis on Gas Discharges." Discusses procedures, instrumentation, and analysis in each example. (CW)

Explains some experiments involving thermal methods of analysis for undergraduate chemistry laboratories. Some experiments are: (1) the determination of the density and degree of crystallinity of a polymer; and (2) the determination of the specific heat of a nonvolatile compound. (HM)

Discussed are selected application and future trends in supercritical fluid chromatography (SFC). The greatest application for SFC involves those analytes that are difficult to separate using GC or LC methods. Optimum conditions for SFC are examined. Provided are several example chromatograms. (MVL)

Presented is a photoelectric colorimeter which can be assembled by the student. Reports that it can do many of the same analyses as the SPEC 20 but at a greatly reduced cost using older technology. Presents several experiments to use with the colorimeter. (MVL)

Concentrates on describing the implementation of the hardware systems based on the BBC microcomputer. Describes the electronic systems used to amplify the signals from the detector and to convert the signal to digital format. Discusses the software that must be used and the system performance. (CW)

Discussed are seven computer programs: (1) a computer graphics experiment for organic chemistry laboratory; (2) a gel filtration simulation; (3) judging spelling correctness; (4) interfacing the TLC548 ADC; (5) a digitizing circuit for the Apple II game port; (6) a chemical information base; and (7) an IBM PC article database. (MVL)