Chemical safety management is an iterative process where reviews of safety deficiencies (e.g., inspection notes) and failures (e.g., injuries) guide improvement efforts. The present work investigates safety in the school chemistry laboratory through two substudies. First, we interviewed 10 Swedish middle and high school chemistry teachers about…

The guide presents information about ordering, using, storing, and maintaining chemicals in the high school laboratory. The guide also provides information about chemical waste, safety and emergency equipment, assessing chemical hazards, common safety symbols and signs, and fundamental resources relating to chemical safety, such as Material…

Presents a scenario related to the disposal of potentially dangerous ether. Several suggestions for dealing with peroxide-forming compounds are included. (JN)

Discusses storage of hazardous chemicals and provides a list of eight basic safety rules to use in developing a safe storage system. Suggestions include not storing materials alphabetically, storing nonreactive chemicals together, and not storing oxidizers and fuels together. (JN)

Discusses topics and issues related to conducting dangerous and/or potentially dangerous demonstrations. Includes a number of resources that secondary and college teachers can consult for additional information. (JN)

Discusses various aspects related to negligence on the part of chemistry teachers. Areas addressed include negligence in tort law, avoiding negligence suits, proper instructions, proper supervision, equipment maintenance, and other considerations such as sovereign immunity, and contributory versus comparative negligence. (JN)

Summarizes advice from the Laboratory Safeguards Subcommittee of the Association for Science Education related to flames and heat, hazardous chemicals, electricity and dangerous voltages, and mechanical hazards. Knowledge is cited as the key to preventing accidents in physics laboratories. (DH)

Compares safety in the chemical industry to academic chemistry laboratories based on the incidence rate for minor industrial injuries compiled by the U.S. Department of Labor, Bureau of Labor Statistics and the author's estimate of academic rates. Provides a list of over 50 errors and omissions commonly found in chemical laboratories. (JM)

Describes safety practices for laboratory fume hoods based on certain assumptions of hood design and performance. Also discusses the procedures in preparing to work at a hood. A checklist of good hood practices is included. (JM)

This study was designed to ascertain the current practices of eye safety in Arizona high school industrial education laboratories, including the enforcement of eye safety legislation, use of eye protection devices, how the eye ware meets the American National Standards Institute specifications, and the teachers' interpretations of the existing eye…

Designed for high school science teachers, the document warns of potential health threats of performing certain experiments and using certain chemicals or chemical combinations in their courses. Following a rationale for more carefully considering health dangers, the document gives suggestions on what can be done by teachers. Reports such as a…

Describes events leading to a flood in the Wehr Chemistry Laboratory at Marquette University, discussing steps taken to minimize damage upon discovery. Analyzes the problem of flooding in the chemical laboratory and outlines seven steps of flood control: prevention; minimization; early detection; stopping the flood; evaluation; clean-up; and…

This manual describes four program areas in vocational education safety instruction: (1) introduction to a safety program; (2) resources to ensure laboratory safety; (3) safety program implementation; and (4) safety rules and safety tests. The safety rules and tests included in section four are for the most common tools and machines used in…