Kundt's tube is a popular experiment commonly used in schools, in which standing sound waves are made visible inside a glass tube. A fine powder is stirred up in areas of high sound particle velocities, so that one can measure the wavelength of the sound waves by examining the patterns created. In this way, the 'invisible' can be made visible.…

Water exhibits a maximum in density at normal pressure at around 4° degree temperature. This paper demonstrates that during cooling, at around 4 °C, the temperature remains constant for a while because of heat exchange associated with convective currents inside the water. Superficial approach implies it as a new anomaly of water, but actually it…

The glowing discharges of plasma obtained by introducing direct current high voltages between two electrodes in a chamber that contains a low pressure gas produces a spectacular effect that makes it attractive to be used as a laboratory experiment for students. Setting up this experiment is however costly and has crucial safety issues to be…

A well known physics problem is to calculate the friction forces required to support a ladder against a wall. A more tractable problem is to calculate the friction forces needed to support an inclined beam on a ball or a cylinder. In the latter case there are three rather than two points of sliding support. Measurements and calculations are…

The impact force and duration when one billiard ball collides head-on with another is estimated by assuming that the balls are connected by a spring. The results are compared with a measurement when a billiard ball collides with a heavy, rigid surface.

The article describes research work that can help students observe and experimentally research the effects caused by the emission component of the filament current in fluorescent lamps' cathodes. When analysing the work of electronic devices--multi-purpose lamps that use thermionic emission--research usually focuses on the current caused by the…

A method is described to measure the coefficient of restitution (COR) by dropping a ball on a piezoelectric disk. Multiple bounces can be observed at small drop heights, so the average COR over say ten bounces can be obtained from just one ball drop, without having to measure the bounce height or the bounce speed. The results show directly that…

This work presents the design of an inexpensive electronic system to measure water temperature and generate an experimental data set used to verify the fitting between experimental and theoretical curves of a water-cooling process. The cooling constant is computed with three different theoretical methods to check their efficiency and this approach…

Light spectrum dispersion is an exciting subject in science because of its beautiful atmospheric colour phenomenon which attracts students. However, to see the phenomenon is not easy since it needs a spectrometer, which is commonly expensive. Therefore, the present study aims to describe a low-cost spectrometer for investigating lighting spectrum…

Air pollution is one of our day's significant reasons for human health problems and affects every community throughout the world. Monitoring air pollution is a key aspect of raising awareness and pollution mitigation approaches followed by different nations. This paper targets to develop a low-cost Internet of things-based embedded system to…

The flight of a quadcopter drone, readily available as a toy, is analyzed using simple physics concepts. A smartphone with built-in accelerometer and gyroscope was attached to the drone to register the accelerations and angular velocities along the three spatial axis while the drone is taking off, landing or rotating. The vertical speed, the…

The current pandemic era demands distance learning, including physics experiments on the topic of optics. One of the optical phenomena that needs to be explained in optic courses is fluorescence. This study offers a simple home experiment regarding the application of fluorescence, namely to identify the purity of olive oil using simple…

In the field of physics teaching, the simple pendulum provides a very simple way to study the harmonic oscillator, the source of some fundamental concepts such as periodicity, relaxation time and anharmonicity. As such, its experimental study is frequently integrated into high school or first year university programs. With this in mind, in this…

In this paper a well-known experiment is considered that is used to demonstrate some aspects of water boiling. It is shown that the currently popular explanation is wrong and a better explanation is proposed, backed up with experimental data. Variations of the experiment are proposed that can be used for a more in-depth examination of the…

A novel method of measuring the coefficients of kinetic and rolling friction is proposed. The method is simple to implement and reliable. Samples of measurements and calculations are presented.