A 2.7 m long stringless pendulum was set up to measure the coefficient of rolling friction of various balls, at higher rolling speeds than usually observed with a short stringless pendulum. The arrangement is easy to set up and makes an impressive classroom demonstration as well as an interesting laboratory experiment.

In this study, we derived several formulas for the currents induced in a circular loop by a magnet connected to a spring-based simple harmonic oscillation system. In addition, we conducted an experiment for measuring the induced currents and compared the results with the theoretical prediction. It was confirmed that the prediction from the derived…

The article introduces a low-cost Arduino sensor into the Young's modulus determination laboratory for physics university students. A stainless steel ruler is used as a cantilever beam. Its free end attached a mass is slightly bent and released to make it oscillate as a simple harmonic motion. The Arduino sensor detects the moving mass's frequency…

The pendulum was an important scientific instrument in the 17th century. It became a typical textbook problem in the 18th century. After the introduction of vectors in physics in the 1890s, the pendulum problem started to be progressively solved in the manner we know nowadays from introductory mechanics courses. Starting from "F = ma"…

The dynamic study of pendulum systems is considered an indispensable subject for physics and mechanics students in colleges and high schools. In this paper, a detailed methodology is given concerning the use of smartphones in pedagogical practical work for studying the dynamics of pendulum systems. Whereas, three aspects have been discussed…

An experiment is described where a billiard ball and a golf ball were projected with backspin on a horizontal surface to measure the transition from sliding to rolling. During both phases, the torque on the ball is affected by an offset in the line of action of the normal reaction force.

The purpose of this publication is to present a novel approach to the demonstration of the Dzhanibekov effect. The main idea of our version is to use a lightweight spinning top of a spherical external form but distinct principal moments of inertia floating in the upward flow of air. As a result, the Dzhanibekov effect can be easily demonstrated…

In general, undergraduate experimental physics laboratories do not usually have experiments designed to address rolling friction and to measure the value of the rolling friction coefficient. This work explores an experiment, which has the potential to arouse students' curiosity about rolling friction by addressing a counterintuitive aspect of the…

The present study reports an Arduino-based STEM education material that resolves the kinematics of a moving object, specifically focusing on two dimensional motion of the object. Throughout the work, a sample application that can be prepared in a classroom where students are active and including the acquisitions of Technology, Engineering, Physics…

A simple experiment is described to compare the descent time between two vertically separated points when an object slides down tracks of varying shape. A surprising result is that the descent time is shortest when it follows a circular track rather than a cycloidal track. Cycloidal tracks are usually predicted to result in the shortest descent…

If a smooth ball is dropped vertically without spin on a smooth horizontal surface then one might expect the ball to bounce vertically without spin. If it does not then the centre of mass of the ball does not coincide with its geometric centre. An experiment is described where a billiard ball and a superball are deliberately biassed by adding a…

A loop-the-loop experiment is described to show how sliding friction affects motion of the ball. Conservation of energy can be used to explain the basic physics, but significant energy loss is observed in practice and expands the usefulness of this apparatus as a teaching tool.

A loop-the-loop experiment usually involves a ball rolling around a vertical loop. A different version of the experiment is described where a nut was allowed to slide around a vertical loop. In both experiments there is a large decrease in kinetic energy when the ball or the nut first enters the loop.

The trajectory of a ball rolling across an inclined plane was recorded on video film to determine if it followed a parabolic path as others have suggested. The challenges in this case were (a) to determine the magnitude and direction of the friction force on the ball, (b) to determine the effect of the friction force on the trajectory and (c) to…

A collision of one object with two or more objects is relatively complicated in general, but a simple example is provided by Newton's cradle since all the objects are identical and in line. In the present paper, an experiment is described where a heavy mallet collides head-on with two billiard balls. The two conservation equations indicate that…