The toppling motion of falling chimney stacks has been the subject of a number of studies which address the interesting phenomenon that brick chimneys usually break well before they hit the ground. Modern concrete chimneys, and wind generator towers, however, are strong enough to topple without breaking and many videos of their destruction are…

This paper reports on the measurement of a magnetic field due to the coil carrying current by using the magnetic sensor in a smartphone as an alternate to the relatively expensive magnetic sensor probe. The location of the magnetic sensor in the smartphone was known by mapping the value of the magnetic field due to the permanent magnetic bar so…

The experiment in charging and discharging of a capacitor through a resistor is fundamentally important for studying electronics. We have developed an alternative procedure to measure the voltage drops across capacitors as a function of time. The simple apparatus controlled by an Arduino Uno microcontroller board and LabVIEW™ interface was set up.…

The glowing discharges of plasma obtained by introducing direct current high voltages between two electrodes in a chamber that contains a low pressure gas produces a spectacular effect that makes it attractive to be used as a laboratory experiment for students. Setting up this experiment is however costly and has crucial safety issues to be…

The oscillations of one mass "m" suspended between two different springs, assuming a friction force proportional to the velocity [minuscule], have been studied. For this purpose, an assembly for this system has been made. The movement of the mass is recorded with a smartphone and analysed with "Tracker." It is obtained that the…

In this paper, we propose a simple yet generic and versatile method to measure the position of a moving body as a function of time. Apart from very basic equipment such as carts and wheels, only a laser pointer or a similar device and a smartphone are necessary. By attaching a source of light to a cart and video filming its movement on a…

A simple and economical system that allows one to obtain the characteristic "I-V" curve in solar cells is presented. It is a computer-controlled system suitable as an instrumentation project for students who are learning about photovoltaic systems. This system is based on the use of an "R-3R" ladder circuit as a variable…

We present several applications of the particle camera MX-10 in different radiation environments, leading to strikingly different observed patterns and consequently particle composition as well as recorded dose. We describe the measurements of the radiation background, cosmic muons direction analysis and the detection of alpha particles in a…

This paper describes the design process for a digital instructional sequence on introductory quantum physics for upper secondary education. Based on a collaboration between teachers and physics education researchers, this sequence incorporates relevant theoretical foundations from the field of science teaching to promote meaningful and conceptual…

Similar to how stealth materials were developed to reduce the radar wave energy returning from an aircraft, here we explore a low-cost laboratory demonstration that uses similar principles to prevent detection of an object by an ultrasonic sensor. This demonstration setup can be used as a starting point to encourage students to explore the surface…

Collisions are a key topic in physics and engineering education. An experiment with multiple body one-dimensional collisions is presented, aiming to measure relevant physical quantities by tracking the motion of the system of particles during the collision. Relations between different physical quantities can be explored in the experiment, such as…

Charging a capacitor with a photovoltaic module is an experiment which reveals a lot about the modules characteristics. It is customary to represent these characteristics with an equivalent circuit whose elements represent its physical parameters. The behavior of a photovoltaic module is very similar to that of a single cell but the electric…

Newton's cradle is a well-known physics toy that is commonly used by teachers to demonstrate conservation laws in mechanics. It can also be used to investigate the physics of colliding objects, by recording motion of the balls on video film. Various experiments are described using 3-ball and 5-ball cradles, showing how different types of collision…

The action of hammering a nail into wood is examined in terms of the force, momentum and energy required. Some unexpected experimental results are also presented.

This work deals with the experimental demonstration of coupled oscillators using simple tools in the form of mechanical coupled pendulums, magnetically coupled elastic strings or electromagnetic oscillators. For the evaluation of results the data logger Lab Quest Vernier and video analysis in the Tracker program were used. In the first part of…