NotesFAQContact Us
Collection
Advanced
Search Tips
Showing all 6 results Save | Export
Peer reviewed Peer reviewed
Direct linkDirect link
Nunn, John – Physics Education, 2015
The speed of sound in a solid is determined by the density and elasticity of the material. Young's modulus can therefore be calculated once the density and the speed of sound in the solid are measured. The density can be measured relatively easily, and the speed of sound through a rod can be measured very inexpensively by setting up a longitudinal…
Descriptors: Measurement Techniques, Acoustics, Computer Software, Technology Uses in Education
Peer reviewed Peer reviewed
Direct linkDirect link
Nunn, John – Physics Education, 2016
This paper demonstrates some simple applications of how temperature logging systems may be used to monitor simple heat experiments, and how the data obtained can be analysed to get some additional insight into the physical processes. [For "DIY Soundcard Based Temperature Logging System. Part I: Design," see EJ1114124.]
Descriptors: Climate, Physics, Science Instruction, Science Education
Peer reviewed Peer reviewed
Direct linkDirect link
Nunn, John – Physics Education, 2016
A cordless mouse with an added reed switch is used as a wireless data logger to record every time the wheel of a trolley completes a revolution. The limitations of the system in terms of maximum clicking rate and spatial resolution are considered and data obtained from the descent of a trolley down a ramp at various different angles is analysed in…
Descriptors: Computer Peripherals, Computers, Computer Uses in Education, Computer Interfaces
Peer reviewed Peer reviewed
Direct linkDirect link
Nunn, John – Physics Education, 2016
This paper aims to enable schools to make their own low-cost temperature logging instrument and to learn something about its calibration in the process. This paper describes how a thermistor can be integrated into a simple potential divider circuit which is powered with the sound output of a computer and monitored by the microphone input. The…
Descriptors: Climate, Physics, Science Instruction, Science Education
Peer reviewed Peer reviewed
Direct linkDirect link
Nunn, John – Physics Education, 2014
This paper describes how a microphone plugged in to a normal computer can be used to record the impacts of a ball bouncing on a table. The intervals between these impacts represent the "time of flight" of the ball. Since some energy is lost in each rebound, the time intervals get progressively smaller. Through calculation it is possible…
Descriptors: Science Instruction, Acoustics, Science Experiments, Computers
Peer reviewed Peer reviewed
Direct linkDirect link
Nunn, John – Physics Education, 2014
A simple inductive gravimeter constructed from a rigid plastic pipe and insulated copper wire is described. When a magnet is dropped through the vertically mounted pipe it induces small alternating voltages. These small signals are fed to the microphone input of a typical computer and sampled at a typical rate of 44.1 kHz using a custom computer…
Descriptors: Science Instruction, Physics, Laboratory Equipment, Magnets