Describes a laboratory explosion involving 30 percent hydrogen peroxide being heated on a ceramic-top hotplate. Gives three safety suggestions: peroxides should be treated as potential explosion hazards; alternatives to the ceramic-top hotplate for these reactions should be considered; and lab workers should be prepared for the worst possible…

Describes events leading to a flood in the Wehr Chemistry Laboratory at Marquette University, discussing steps taken to minimize damage upon discovery. Analyzes the problem of flooding in the chemical laboratory and outlines seven steps of flood control: prevention; minimization; early detection; stopping the flood; evaluation; clean-up; and…

Described is a plan used in Iowa to remove stockpiled, unwanted chemicals from storeroom shelves. Points out that the plan takes 12-15 months to complete. Notes the average cost per district was $575. (MVL)

Summarizes several articles on safety in the science laboratory, an article on the science and history of chocolate, and an article on teaching nuclear physics from an historical perspective. (WRM)

Highlights aspects of safety that are unfamiliar to most laypersons and to many chemists as well. Presents findings that may lend themselves to presentation in chemistry classes. Details flammability tests, vapor space hazards, and the special case of gasoline containers. Provides experimental data relating vent area and internal pressure. (CW)

Discusses the need for chemistry laboratory safety procedures. Provides descriptions of techniques to increase students' awareness of the symptoms of such things as toxic gas clouds that could escape into the laboratory, along with defensive strategies for reacting to such situations. (TW)

Reports on a chemistry laboratory accident intervention study conducted throughout the state of Colorado. Addresses the results of an initial survey of institutions of higher learning. Discusses some legal aspects concerning academic chemistry accidents. Provides some observations about academic chemistry laboratory accidents on the whole. (TW)

Recounts a high school chemistry lab explosion while distilling alcohols. Proposes peroxide formation in older samples of alcohols as the cause. Lists commonly found laboratory alcohols and their peroxide concentrations. Discusses methodology for both detecting and removing peroxides. (MVL)

Encourages instruction about disposal of hazardous wastes in college chemistry laboratories as an integral part of experiments done by students. Discusses methods such as down-the-drain disposal, lab-pack disposal, precipitation and disposal, and precipitation and recovery. Suggests that faculty and students take more responsibility for waste…

Discusses the need for more safety instruction in high school and college chemistry courses. Reports on a national survey of 2019 college and university chemistry departments. Includes survey results and the descriptions of 50 accidents which the institutions reported. (TW)

Describes the absorption and containment (AC) approach to laboratory chemical-spill cleanup. Discusses currently recommended chemical-spill cleanup procedures and evaluates commercially available cleanup materials. Promotes the use of the AC method in terms of its relative safety, availability of materials, and ease of instruction. (TW)

Lists five module objectives and discusses the overall need for the modules. Indicates each module is preceded by a statement of the problem and objectives are aimed specifically at the anticipation and reduction of potential hazards. Offers examples of modules on fume hoods and on disposal of waste. (MVL)

Describes a program in which six experiments in chemistry were used in an elementary school science program. Discusses the problems encountered in initiating the program, and some of the ways the problems were solved. Lists the six experiments, along with the reaction or process being studied, and the application of each. (TW)

Describes two courses in chemical safety required as a part of a two-year program in chemical technology offered by the Northern Alberta Institute of Technology (Canada). Lists the topics covered in each course. Provides descriptions of hand-outs, audiovisual materials, demonstrations, assignments, and examinations used in the courses. (TW)

Argues for the introduction of a college level safety course for chemistry majors and surveys college catalog offerings to determine course status in American Chemical Society approved departments. Concludes that six percent of approved departments offer a formal safety course. (ML)