Mobile phones are a widely used platform for educational apps, mobile health, and a variety of chemical tests. Here, we are working on a mobile phone-based physics lab (mPhysics) that uses a mobile phone's capabilities to run simple physics experiments and demonstrations. While a mobile phone can be used to analyze magnetic and optical properties…

A common misconception about dissolving is that heating and/or stirring are required for the dissolving process to occur. In this study, quantitative experimental evidence was collected and analyzed to demonstrate that neither heating nor stirring is required for dissolving. Educators can use the data and results in this study to address this…

Using everyday life examples is proven didactically useful for teaching physics, as it presents effective applications of physical laws. Cooking and food, in particular, serve two useful purposes: on one side, they are able to engage students in the study of physics with familiar examples; on the other side, thanks to the wide range of physical…

In the present theoretical study, we introduce the entropy concept into Chi's ontological shift theory. Chi distinguishes between two categories of process phenomena, direct and emergent, and claims that incorrectly considering emergent processes as direct ones is one of the sources of students' robust scientific misconceptions. The present study…

Coffee cup calorimetry, performed with calorimeters made with styrofoam coffee cups, is a familiar experiment in the general chemistry laboratory. These calorimeters are inexpensive, easy to use, and provide good insulation for most thermodynamics experiments. This paper presents the successful substitution of paper coffee cups for styrofoam cups…

A method to determine the temperature dependence of copper wire resistance is described in this paper.

In this paper, we present a low-cost method to study the Gay-Lussac's law. We use a heating wire wrapped around the test tube to heat the air inside and make use of a solid state pressure sensor which requires a previous calibration to measure the pressure in the test tube.

This laboratory investigation challenges students to synthesize, analyze, and compare viable alternative fuels to Diesel No. 2 using a renewable resource, as well as readily available reagents and supplies. During the experiment, students synthesized biodiesel from soybean oil in an average percent yield of 83.8 ± 6.3%. They then prepared fuel…

We describe the construction of a simple solution calorimeter, using a miniature bead thermistor as a temperature-sensing element. This has a response time of a few seconds and made it possible to carry out a thermometric reaction in under a minute, which led to minimal heat losses. Small temperature changes of 1 K associated with enthalpies of…